335
To allow a remote PC to connect to the NVR and the IP cameras, do the following:
Step 1. Set up the port mapping (virtual server) on the router.
Step 2. Add the IP camera to the NVR by entering the IP address of the IP camera in
the ‘IP Address’ settings. Enter the public IP address of the router and the mapped
ports of the IP camera in the ‘WAN IP Address’ settings.
Note: When configuring the IP camera, the WAN IP and LAN IP must be entered.
To open FTP (port 21) and SMB (port 445) of the NVR on WAN, configure the
following port mapping settings:
After finishing the above two steps, connect to the NVR on WAN by entering the IP
address http://219.87.144.205:8000 in the IE browser. Then login the NVR with the
correct user name and password.
If the port specified to the NVR is 80, enter http://219.87.144.205 to connect to the
NVR.
Note: If the router does not use a fixed IP, configure the DDNS settings on the router.
Other configurations are the same as above.
Commentaires sur ces manuels