QNAP VS-8124U-RP PRO+ Manuel d'utilisateur télécharger pdf (Page 261)

100

101

261

connected to the UPS by a USB cable.

Choose between whether the NVR will shut down or enter auto-protection mode

after AC power fails. Specify the time in minutes that the NVR should wait before

executing the option you have selected. After the NVR enters auto-protection

mode, the NVR resumes the previous operation status when the power restores.

5.Enter the “IP address” of other network UPS slaves to be notified in the event

of power failure.

6.Click “Apply All” to confirm and continue the setup for the NVR systems which

operate in network slave mode below.

Network slave mode

A network UPS slave communicates with network UPS master to receive the UPS

status. To set up your NVR with UPS as network slave mode, follow the steps below:

1. Make sure the NVR is connected to the same physical network as the network

UPS master.

2. Select the option “Enable UPS Support”.

3. Select “Network UPS slave” from the “Protocol” drop down menu.

4. Enter the IP address of the network UPS server.

5. Choose between whether the NVR will shut down or enter auto-protection

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 351 352

Commentaires sur ces manuels

Pas de commentaire

QNAP VS-8124U-RP PRO+ Manuel d'utilisateur Page 261

Commentaires sur ces manuels