QNAP VS-8124U-RP PRO+ Manuel d'utilisateur télécharger pdf (Page 260)

100

101

260

SNMP-based UPS.

Select the option “Enable UPS Support”.

Select “APC UPS with SNMP management” from the “Protocol” drop down menu.

Enter the IP address of the SNMP-based UPS.

Choose between whether the NVR will shut down or enter auto-protection mode

after AC power fails. Specify the time in minutes that the NVR should wait before

executing the option you have selected. After the NVR enters auto-protection

mode, the NVR resumes the previous operation status when the power restores.

Click “Apply All” to confirm.

Network master mode

A network UPS master is responsible for communicating with network UPS slaves on

the same physical network about critical power status. To set up your NVR with UPS

as network master mode, plug in the USB cable on the UPS to the NVR and follow the

steps below:

Make sure the NVR (the “UPS master”) is connected to the same physical

network as the network UPS slaves.

Select the option “Enable UPS Support”.

Click “Enable network UPS Support”. This option appears only when your NVR is

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 351 352

Commentaires sur ces manuels

Pas de commentaire

QNAP VS-8124U-RP PRO+ Manuel d'utilisateur Page 260

Commentaires sur ces manuels