218
Note that all the data on the selected hard drive will be cleared. Click “OK” to
confirm.
When migration is in process, the required time and total drive capacity after
migration are shown in the description field.
The NVR will enter “Read only” mode when migration is in process during 11%–49%
to assure the data of the RAID configuration will be consistent after RAID migration
completes.
After migration completes, the new drive configuration (RAID 5) is shown and the
status is Ready. You can start to use the new drive configuration.
The process may take from hours to tens of hours to finish depending on the hard
drive size. You can connect to the web page of the NVR to check the status later.
Use Online RAID Capacity Expansion and Online RAID Level Migration
Add a hard drive
Follow the steps below to add a hard drive member to a RAID 5 or RAID 6 disk
configuration.
Make sure the status of the RAID 5 or RAID 6 configuration is “Ready”.
Install a hard drive on the NVR. If you have a hard drive which has already been
Commentaires sur ces manuels